Autodesk inventor 2017 tips and tricks free download.60 Inventor Tips in 60 Minutes | Autodesk University

Galkis

In my opinion you are not right. I am assured. I suggest it to discuss.

I apologise, but this variant does not approach me. Who else, what can prompt?

Mogar

Excuse, that I can not participate now in discussion - it is very occupied. But I will be released - I will necessarily write that I think on this question.

It is not pleasant to me.

Dougrel

Very good phrase

I advise to you to visit a site on which there are many articles on this question.

Bazilkree

And on what we shall stop?

Feb 06,  · Ground and root the part model in a container assembly. Add the 1" cube and constrain it to the origin planes. Adjust the constraint values so that the assembly COG matches the vendor spec. Set the Assembly BOM value to "Inseparable". Add all the vendor info to the container assembly iProps. Inventor

Akijas

Now all became clear, many thanks for the help in this question.

Feb 06,  · Ground and root the part model in a container assembly. Add the 1" cube and constrain it to the origin planes. Adjust the constraint values so that the assembly COG matches the vendor spec. Set the Assembly BOM value to "Inseparable". Add all the vendor info to the container assembly iProps. Inventor